Plaka Clamp - edge formwork 04.20.02

1. Fitting spacers and shoes on the load-bearing walls, every 60 cm. No drilling required. The shoe is blocked by a single nail, which is slid into the appropriate hole.

2. Fitting formwork boards onto the shoes. Perfect coating of steel reinforcements. The shoes are designed for 27 mm thick formwork boards. For other thickness values, use the appropriate accessories (refer to the Accessories section).

3. Concrete casting. Formwork height up to 30 cm.

4. To strip, remove the nail, which releases the shoe as well as the formwork board. Then fold and unfold the spacer until it breaks.

1. Adjusting plate allowing adjustment according to the thickness of your formwork board, varying between 27 and 63 mm (63 mm is the thickness of a baulk or a common rafter)

2. Adaptable reinforcement stiffener for making beams and lintels (used with straight spacers, see below)

3. Straight alu spacers for constructing collar beams. In this case we use 2 blocks, mounted opposite each other (available in several dimensions)

4. Riser for the collar beam and slab in a single formwork. Riser for constructing beams up to 50 cm height

5. Adjustment plate to adjust thickness of your formwork board from 15 to 27 mm.

6. Standard aluminium spacer (available in several dimensions)