Adjustable notchblock 04.18.30
Add to my wish listAdjustable system for adding pre-slab supports to load-bearing partitions.
- Course on the same level on both sides of the shell
- Minimum pre-slab bearing of 2.5 cm observed
- No interference from the pre-slab prestress wires
- The standby rods (leeks) must be planted after concreting
- The blocks are used as spacers at the top of the formwork
- Blocks dampened on many reuses
- Avoids picking, the formwork under pre-slabs or cutting of magnetized hawks
- Allows striking off at inaccessible levels
- Prevents laitance leakage when casting the slab (foam gasket or 30/3 mm bearing on engraving)
- Screed finish removed
- Easy use in formwork (2.50 ml hawks for 2 blocks
- form panel)
- The shell end pieces are cut to allow the hawks to pass
When sealing the walls, it is important to avoid hitting the existing system.
